Hi,
I have a Dash 0-12000rpm, but my motor only revs up to 10500. I would like the 9000-12000 bars display 9000-10500rpm. Unfortunately, the Tacho output function can only vary the duty cycle.
Can I use an AuxN as frequency output, where the frequency value comes from a table ?
Angelo
non-linear tacho output
3 posts
• Page 1 of 1
non-linear tacho output
by Polux RSV on Thu Jun 04, 2009 9:05 pm
- Polux RSV
- Posts: 90
- Joined: Wed Feb 18, 2009 4:18 am
Re: non-linear tacho output
by Polux RSV on Fri Jun 05, 2009 12:40 am
Post about similar problem found here http://www.motec.com.au/forum/viewtopic.php?f=11&t=543&p=2476&hilit=frequency+table#p2476
but no answer.
Angelo
but no answer.
Angelo
- Polux RSV
- Posts: 90
- Joined: Wed Feb 18, 2009 4:18 am
Re: non-linear tacho output
by RossB on Fri Jun 05, 2009 10:15 am
To do this you would need a duty cycle and frequency function, the M800 doesn't have this.
- RossB
- Posts: 474
- Joined: Thu May 01, 2008 2:57 pm
3 posts
• Page 1 of 1
Return to M400, M600, M800 and M880 ECUs
Who is online
Users browsing this forum: No registered users and 81 guests