MoTeC Global Forum

Posted: **Wed Apr 29, 2009 8:44 pm**

Hi,

Motec, would it be possible to have the choice of varying Frequency at a fixed duty cycle on an Aux Table?
I would like to use this for driving a Stepper Boost gauge and also an OEM Speed gauge.

Thanks
Martin

Posted: **Thu Jul 09, 2009 8:51 pm**

Posted: **Fri Jul 10, 2009 9:37 am**

Hi Martin,
This has been a request for quite some time now but no answer as yet from the software guys. I will prompt them again.

Posted: **Sat Jul 11, 2009 2:25 am**

Thanks Mark!

Posted: **Tue Jul 14, 2009 8:20 pm**

I had the same request. :cry:

I used an aux PWM table and an external small microcontroller. It reads the PWM from the M800, and generate the right freqency with its internal timers, to drive the Marelli Dash. Good results. But should be better if this could be replaced by a simple wire :lol:

Martin, another simpler solution is to generate a variable voltage filtering a PWM. This voltage drives then a LM331 (voltage to frequencer converter, http://www.national.com/ds/LM/LM231.pdf) which generate the right frequency.

Angelo

MoTeC Global Forum

Aux Table Configuration for Variable Frequency

Aux Table Configuration for Variable Frequency

Re: Aux Table Configuration for Variable Frequency

Re: Aux Table Configuration for Variable Frequency

Re: Aux Table Configuration for Variable Frequency

Re: Aux Table Configuration for Variable Frequency