MoTeC Global Forum

Is there any technical drawing besides the M2R ones that
describe the 4 coil setup for a 2 rotor? I am thinking the 140/141
mode described in the M2R notes is what I should be using when
wiring/setting up my ignition? There is a dwg. (M24) which is referencing the
M4-M8 as well, however, since my ecu is an M600 I think the M2R
is what I should reference. Any help would be appreciated.
Motor is full race Mazda 12a-N/A, road racing use

Best,
Guil

Hi,

Have a look at document M47, this is the wiring for the CDI, but it is the way that the wiring is done for Mode 140.