MoTeC Global Forum

Hi All,

I'd have the need of controlling individual coils dwell based on BatV VS MAP VS RPM:
how could I do it?
I saw the latest software but it seems to me that there is only a 2 Axys map for dwell..

Thank you.

Use a spare aux output as an aux table.
Set the axes as MAP and RPM use tis table to total the differences you want to make on these two channels.
Use the Aux output duty cycle channel produced by this table as the second axis against BatV on your Dwell table.

IDP wrote:Use a spare aux output as an aux table.
Set the axes as MAP and RPM use tis table to total the differences you want to make on these two channels.
Use the Aux output duty cycle channel produced by this table as the second axis against BatV on your Dwell table.

Unfortunately I used all my M400 #8 aux outputs, #4 injector outputs and #4 ignition outputs...

Do you have an SDL/ADL?

IDP wrote:Do you have an SDL/ADL?

No...