Function controlled by the CAN communication
Posted: Tue May 13, 2014 2:43 am
Hello, everyone
I have a CDL and PDM and M800.
I want to switch from input of PDM or CDL, the input function of M800.
I'm thinking also to use the keypad.
In any event, is it possible to control the input function of M880 in the CAN communication?
If possible, I want to know is setting
Regards
yuu
I have a CDL and PDM and M800.
I want to switch from input of PDM or CDL, the input function of M800.
I'm thinking also to use the keypad.
In any event, is it possible to control the input function of M880 in the CAN communication?
If possible, I want to know is setting
Regards
yuu