MoTeC Global Forum

Hi all

We are installing an M800 (not plug and play) onto an EVO 5 Lancer. Just after some info concerning the factory 6 pin idle stepper motor. I believe 2 of the 6 pins are ignition 12 volts, but are there specific aux output chanels that need to be connected to the remaining 4 stepper motor pins. Anyone have a wiring diagram or info?

Cheers
Simon

This is specific to 8/9 but should be the same pinout, verify if needed.

************Disconnect the two B+ wires from the 6 pin ISC connector.******************

Aux 5 - ISC connector pin #1
Aux 6- pin #3
Aux 7- pin #4
Aux 8- pin #6

If pins are in wrong position it just wont work, nothing bad should happen.