MoTeC Global Forum

hello

can anyone tell me what are the values wich are predefined in the motec ecus ?

in Sensor input setup i can chose :

#40 Lambda: Bosch Wide Band Meter
#41 Lambda: NTK Wide Bank Meter


wich voltages are there predifined in Motec Software ?

are following Values Correct ?

Bosch Wide Band Meter
Volt = 0,000 1,750
Lambda = 0,000 1,750

NTK Wide Band Meter
Volt = 0,000 5,000
Lambda = 0,500 1,500

is this correct ????

Hi,
These are definitely the calibrations you can see in the ECU manager, so these are the values the ECU uses.

Regards!