MoTeC Global Forum

Hi guys,

I'm trying to build a FSAE car with a GSXR-600 engine.

First I had to change the camshaft pin so the crank & cam signals won't be clashing.

I've been configuring mag voltages and so on but I still have an error which I don't understand.

I let you the ref/sync capture and the errors:





I let you the link to the second image since I'm not able to see it properly in my navigator: http://i.imgur.com/IIUdz.jpg

When I changed the cam pin I think it didn't fit very well and the cam signal was too big comparing to the crank signal. I managed to fit a little more and now both signals have the same peak voltage. By default the cam signal was a little bit bigger but I think both signals are clean enough to read.

I'm using ref/sync mode 7, teeth number 24.

Thanks guys

Hi again,

We managed to make that work.

Now we're getting a Over RPM error and we don't know what does it mean since we don't have any RPM limit set.

Do you need the file in this case?

Regards,

Sabo