MoTeC Global Forum

I have a problem, I have climbed on a m800 wrx78 and I have connected a SDC with line Can, unfortunately it doesn't acquire me the data, in the ECU Manager I have planned the Khan setup in the following way:
-Can 1 date: 5
-Can 1 address: 96
-Can 1 transfer Installments: 50
I have made some error or it misses some information
Thanks

Hi,

The SDC2 to M800 comms is via RS232 to make use of the factory wiring loom.
For setup follow the instructions on page 19 of the SDC2 manual available here http://motec.com.au/filedownload.php/SDC2%20User%20Manual.PDF?docid=2149

CAN communication from the SDC2 is for connecting to a ADL/2 Dash logger and for programming the SDC2.

Regards,