Page 1 of 1
Dual rpm error window
Posted:
Mon Nov 01, 2010 3:23 amby Wolf_Tm250
Hi,
anytime I press the clutch and hit dual rpm limit, I get an error window on my Car-PC that stays there until i press "OK" in the window:
any idea how not to get this error window anytime I am in those conditions?
Thank you.
Re: Dual rpm error window
Posted:
Mon Nov 01, 2010 8:22 pmby SprinterTRD
The error is displayed because dual rpm is active and you shouldn't tune a engine when it is active.
Re: Dual rpm error window
Posted:
Tue Nov 02, 2010 3:29 amby Wolf_Tm250
SprinterTRD wrote:The error is displayed because dual rpm is active and you shouldn't tune a engine when it is active.
Ok thanks, makes sense.
So is there any way to remove this warning?
Thanks.
Re: Dual rpm error window
Posted:
Tue Nov 02, 2010 8:15 pmby SprinterTRD
Yep, don't activate the dual rpm rev limit when you have the laptop connected!
Re: Dual rpm error window
Posted:
Tue Nov 02, 2010 11:52 pmby Wolf_Tm250
SprinterTRD wrote:Yep, don't activate the dual rpm rev limit when you have the laptop connected!
Unfortunately this is not a solution...
I built a m400 permanent connected car-pc to have in dash gauges, so my "laptop" is always connected...
Wolf
Re: Dual rpm error window
Posted:
Wed Nov 03, 2010 3:12 pmby SprinterTRD
I would sat that the warning is hard coded into the PC tuning software.
The only way to get around it is to possibly get the Telematry upgrade and use Telematry monitor for your display instead of the Tuning software.
Re: Dual rpm error window
Posted:
Thu Nov 04, 2010 5:05 amby Wolf_Tm250
SprinterTRD wrote:I would sat that the warning is hard coded into the PC tuning software.
The only way to get around it is to possibly get the Telematry upgrade and use Telematry monitor for your display instead of the Tuning software.
Ohh thanks!
Didn't thought about this opportunity...
Wolf