ref/sync mode 53 with the M16A
Posted: Mon Jul 26, 2010 7:25 pmis mode 53 the correct oem mode to use with the suzuki M16A engine.
crank trigger wheel is 36 teeth with 2 missing 3 times.
crank trigger wheel is 36 teeth with 2 missing 3 times.
MoTeC Global Forum
The official support forum for MoTeC products
https://forum.motec.com.au/
ref/sync mode 53 with the M16A
Page 1 of 1
Posted: Mon Jul 26, 2010 7:25 pmRe: ref/sync mode 53 with the M16A
Posted: Thu Aug 26, 2010 12:05 pmTHis should be the correct mode for this engine as used in a Suzuki Swift.
Re: ref/sync mode 53 with the M16A
Posted: Fri Mar 08, 2019 5:59 pmDo you have PID for E-Throttle and Cam Control this engine?
Regards,
Regards,
Re: ref/sync mode 53 with the M16A
Posted: Tue Mar 12, 2019 9:34 amHi,
If you can post the part number of the DBW I can look it up and see if we have done a calibration on it.
Cam PID's really need to be done for each engine, changes in manufacturing tolerances and oil viscosity will make a big difference to the numbers used.
If you can post the part number of the DBW I can look it up and see if we have done a calibration on it.
Cam PID's really need to be done for each engine, changes in manufacturing tolerances and oil viscosity will make a big difference to the numbers used.
Re: ref/sync mode 53 with the M16A
Posted: Fri Jan 28, 2022 5:19 amSDean wrote:Hi,
If you can post the part number of the DBW I can look it up and see if we have done a calibration on it.
Cam PID's really need to be done for each engine, changes in manufacturing tolerances and oil viscosity will make a big difference to the numbers used.
I would like to PID for Bosch E-throttle 0280.750.156.
Advance Thank You,
Re: ref/sync mode 53 with the M16A
Posted: Fri Jan 28, 2022 9:02 amHi,
We have a calibration for this DBW throttle, but I only have access to the calibration for the M1 that doesn't readily translate back to the M800 values. The tech that does the calibrations for the DBW's is out of the office today, but I've asked him to follow up on this when he gets back in on Monday for you.
We have a calibration for this DBW throttle, but I only have access to the calibration for the M1 that doesn't readily translate back to the M800 values. The tech that does the calibrations for the DBW's is out of the office today, but I've asked him to follow up on this when he gets back in on Monday for you.
Re: ref/sync mode 53 with the M16A
Posted: Thu Feb 03, 2022 6:18 pmSDean wrote:Hi,
We have a calibration for this DBW throttle, but I only have access to the calibration for the M1 that doesn't readily translate back to the M800 values. The tech that does the calibrations for the DBW's is out of the office today, but I've asked him to follow up on this when he gets back in on Monday for you.
Thanks for reply, waiting for your reply again.