MoTeC Global Forum

Can an input be configured to add a fixed value of idle control duty cycle when the transmission is engaged into gear?

Not sure if this is the "correct" way to do what you want but I'd look at the initial position table for the idle control and add a Y axis based on the switched input from the Trans selector and have it add/subtract some initial as needed.

Thanks I will have a go.

Cant get a Y axis up on any of the idle control tables.

What will work though is by using the power steering switch input and then the idle control set-up has that provision.

Very strange I have X/Y axis on my Idle Normal Position table.

Which software/firmware are you running?

Am running 3.52J..........it's probably me.

When viewing the Idle normal position table hit the A key.

You will then have the dialog box to add the 3rd axis.

Thanks.