MoTeC Global Forum

Hello,
I'm totally new to the M800 and I hope that you'll forgive me some stupid questions.

I'd like to take the datastream from the RS232 interface an dsend it wirelessly to an device which can show the data on the screen.
Therefor I need to know how the data stream is coded.
Can you give some Information about the data stream?

Thanks a lot

Jan from Germany

Can't anyone help me?
It is very important.

Thanks Jan

It's still the weekend here you may not get an official response for another 22 hours Jan, one of the regulars may have an answer but most don't hit the forum until Monday anyway.

Oh, Thanks for the hint.

I didn't think about it, that you're down under, so I'll have to wait until tomorrow.


Bye


Jan

So, the Weekend is over,
unfortunately I didn't get any answere.
Can somebody tell me how to get some Information about the problem. Maybe another way?
Please help me.

Jan

To get data out of the M800 you will need to purchase the telematry upgrade from your MoTeC dealer.

You then Use Telemetry monitor to view the transmited data.