MoTeC Global Forum

Now at the stage of awaiting the mapper, and did a full systems check today on an RB26 Skyline engine on M800. I grabbed three screen captures of the crank and reference sensor signals. Crank is 36 minus 1 teeth, magnetic, and cam is a single tooth Hall effect. The engine hasn't had the CRIP set in the software yet. Do these signals look OK to trigger the ecu properly please?

http://www.chriswilson.tv/rsc.zip

Thanks!

Out of interest what opens a .rsc2 file?

Motec ECU Manager software, but only version 3.5 onwards I think? Open the Ref / Sync Capture app and then use the Load button to load a capture file to view.
Here's a partial screen shot: