MoTeC Global Forum

hey is there someone who can tell me what tool to name / number to Crimping pins for M400 ECU. Regards Henrik

Hi

http://www.m-cal.com/Products/MC70-367024/M800-Crimp-Tool

regards Thorsten

While this may not be the 100% *proper* tool, it will handle a WIDE variety of smaller terminals very well, and is very inexpensive;

Molex P/N 063811-1000

http://www.molex.com/molex/products/dat ... Lang=en-US

If you could only carry one crimp tool for your on-site crimping needs for open U style terminals this would be it.

Nothing beats the OEM proper tool, but sometimes you have to make do with what you have.

The 100 series connectors used need a tight roll on the insulation part of the crimp so they will fit in through the waterproof grommet, I got my crimper directly from MoTeC it was worth spending the $ and getting the right tool.

well the connector is an AMP connector which is now owned by Tyco electronics.

A tyco pro-crimper III with the correct die, DONE.

figgie wrote:well the connector is an AMP connector which is now owned by Tyco electronics.

A tyco pro-crimper III with the correct die, DONE.

That's what MoTeC supplied

hi and thanks for your responses. Regards Henrik