m400 run high & low impedance injectors simultaneously?

[edickma1]

Is it possibility for for an M400 to run both saturated and peak & hold injectors at the same time? there are only 4 injectors being considered for implementation, 2 low flow saturated injectors for low loads and 2 higher flow peak and hold injectors for higher loads, is this a possibility?

thanks guys

[MarkMc]

If you run the staged injection you can specify different output control for the two different sets of injectors. I assume it is a two rotor or 2 cylinder engine?

[edickma1]

thank you very much for your response, this is a 2 cylinder aprillia engine

[MarkMc]

Ok, no problem then.