M800 --> SLM
3 posts
• Page 1 of 1
M800 --> SLM
by Mazi on Tue Jun 22, 2010 7:24 pm
M800 CAN transfer rate to SLM is fixed to 50Hz and cannot be changed. Is it true?
-
Mazi - Posts: 146
- Joined: Thu Jul 24, 2008 8:45 pm
Re: M800 --> SLM
by RossB on Fri Jun 25, 2010 4:53 pm
If it is on CAN 1 Data you can set it to 33 Hz. What do you want to change it for?
- RossB
- Posts: 474
- Joined: Thu May 01, 2008 2:57 pm
Re: M800 --> SLM
by Mazi on Mon Jun 28, 2010 8:13 pm
Yes, I can set it to 33Hz, but M800 will send data to SLM in 20ms period.
I want to maintain CAN traffic as low as it is possible because of heavy load from some other devices connected to the same CAN. Just don't want to use CAN router to split the traffic in to two buses yet. I know that amount of data sent to SLM is unimportant, but however.
I want to maintain CAN traffic as low as it is possible because of heavy load from some other devices connected to the same CAN. Just don't want to use CAN router to split the traffic in to two buses yet. I know that amount of data sent to SLM is unimportant, but however.
-
Mazi - Posts: 146
- Joined: Thu Jul 24, 2008 8:45 pm
3 posts
• Page 1 of 1
Return to M400, M600, M800 and M880 ECUs
Who is online
Users browsing this forum: No registered users and 9 guests