Hi i have a M800 ecu which l use for my SBC drag truck. I have recently changed the engine for a GM LS engine. On the original SBC I used a MSD crank trigger system with four rotating magnets on the front pulley. This had a 2 pin connector plug (orange and blue wires) Now on the LS I have the 24x black sensor which is 3 pin. How to I wire the new sensor to work with the M800 system please.
Thanks Kev
Crank trigger problem
2 posts
• Page 1 of 1
Crank trigger problem
by kevdachev on Thu Jul 03, 2025 4:52 am
- kevdachev
- Posts: 21
- Joined: Sat Jul 18, 2015 5:03 am
Re: Crank trigger problem
by Stephen Dean on Thu Jul 03, 2025 11:36 am
Hi Kev,
The attached files should be able to assist in the wiring and setup of this sensor.
The attached files should be able to assist in the wiring and setup of this sensor.
- Attachments
-
T03 Mixed Hall & Magnetic Sensors.pdf- (25.83 KiB) Downloaded 3 times
-
- T01 Hall Effect Sensor General.pdf
- (31.4 KiB) Downloaded 1 time
Stephen Dean
MoTeC Research Centre Melbourne, Australia
MoTeC Research Centre Melbourne, Australia
-
Stephen Dean - Site Admin
- Posts: 1796
- Joined: Tue Dec 02, 2014 10:29 am
- Location: Melbourne
2 posts
• Page 1 of 1
Return to M400, M600, M800 and M880 ECUs
Who is online
Users browsing this forum: No registered users and 4 guests