2004 Subaru STi M800 won't start

[stevieturbo]

Can you scope the signals ?

Did you try contacting Dave Rowe ? He is ex Motec, and he will know how to configure the ecu even if Motec themselves cannot help.

[Holmz]

Can you scope the signals ?

Did you try contacting Dave Rowe ? He is ex Motec, and he will know how to configure the ecu even if Motec themselves cannot help.

Someone maye actually need to look at it, but since the OP's profile does not seem to show even the country, I am not sure how you can suggest a particular person.

[stevieturbo]

Can you scope the signals ?

Did you try contacting Dave Rowe ? He is ex Motec, and he will know how to configure the ecu even if Motec themselves cannot help.

Someone maye actually need to look at it, but since the OP's profile does not seem to show even the country, I am not sure how you can suggest a particular person.

How ?

Doesnt matter where he is for this. Dave will be able to discuss over the phone, Dave will know how to configure the ecu for his setup, and he will be able to email that to him.

The only caveat is that the wiring is correct. But again he would be able to discuss this with the OP.

ideally yes being there in person would be best, but that isnt always possible. Although Dave does also travel all over the world to install and tune Motec and other ecu's

But there is no doubt whatsoever that he will be able to resolve the problem