Did this go anywhere guys? spoke to IJ he can't remember
I have a spare PCS TCM-2000 sitting here at the moment....
CAN protocol used?
12 posts
• Page 2 of 2 • 1, 2
Re: CAN protocol used?
by Allan L on Tue Jun 25, 2013 5:56 pm
Thread dig from the dead!
Did this go anywhere guys? spoke to IJ he can't remember
I have a spare PCS TCM-2000 sitting here at the moment....
Did this go anywhere guys? spoke to IJ he can't remember
I have a spare PCS TCM-2000 sitting here at the moment....
-
Allan L - Posts: 25
- Joined: Mon Aug 08, 2011 4:00 pm
Re: CAN protocol used?
by SprinterTRD on Fri Jun 28, 2013 2:14 pm
Have you got IJ's trans controller? If you have then his MAP should have the CAN setup he used.
- SprinterTRD
- Pro User
- Posts: 378
- Joined: Wed Jul 16, 2008 9:24 am
12 posts
• Page 2 of 2 • 1, 2
Return to M400, M600, M800 and M880 ECUs
Who is online
Users browsing this forum: No registered users and 5 guests