HONDA CBR SETUP(need help)
Posted: Tue Jan 05, 2010 9:13 amDear members
I am using the motec m4 on a honda cbr 600cc engine, i have been trying to start the engine for along time but i could'nt. when ever i try to crank the engine it seems like it wants to start but fails, i checked the ref/sync signal with an osiliscope and it reads 5volts for Ref and 0.3 for sync peak to peak. however when i go to the view screen the sync relative position is -1% which i think it shouldnt be, but when ever i change the number of ref teeth to 4 the SRP goes to 50%. i tried everything to figure the problem and i couldnt so i am stuck.
IJPU=15
IJCU=0
IJbc=4
IJOP=0
EFF=1
LOAD=1
LDS=100
CYLS=4
rFSn=2(mag)
SYSn=2(mag)
rEF=14
crT=12
crip=450
ign=1
coil=2(wasted spark)
dell=3
dly=50
this the ref/sync signals
http://img36.imageshack.us/i/04112009107.jpg/
I am using the motec m4 on a honda cbr 600cc engine, i have been trying to start the engine for along time but i could'nt. when ever i try to crank the engine it seems like it wants to start but fails, i checked the ref/sync signal with an osiliscope and it reads 5volts for Ref and 0.3 for sync peak to peak. however when i go to the view screen the sync relative position is -1% which i think it shouldnt be, but when ever i change the number of ref teeth to 4 the SRP goes to 50%. i tried everything to figure the problem and i couldnt so i am stuck.
IJPU=15
IJCU=0
IJbc=4
IJOP=0
EFF=1
LOAD=1
LDS=100
CYLS=4
rFSn=2(mag)
SYSn=2(mag)
rEF=14
crT=12
crip=450
ign=1
coil=2(wasted spark)
dell=3
dly=50
this the ref/sync signals
http://img36.imageshack.us/i/04112009107.jpg/