MoTeC Global Forum

Posted: **Sun May 09, 2021 11:50 pm**

Hi all,
I am working on an old M4, where the plan is to use AUX 3 to control cooling fan (PWM),
Everything works fine when I am using "test output" (200Hz. from 10% to 90% (below 10 and above 95 it is "off")
But when I am in "normal mode" (with correct values in table etc...), and simulate changing ET (=X-axis) nothing happens, output AUX 3 is always =0.

Have I missed something.....?

EDIT (added screen-shots)

: Aux Output 3; Aux Output 3.png (32.8 KiB) Viewed 8685 times

: Aux Output 3 Test; Aux Output 3 Test.png (29.02 KiB) Viewed 8685 times

: Aux Output 3 Table; Aux Output 3 Table.png (34.48 KiB) Viewed 8685 times

Posted: **Tue May 11, 2021 12:17 am**

: Aux Output 3 Parameters; Aux Output 3 Parameters.png (36.87 KiB) Viewed 8684 times

(only three attachment in one post.... :cry:

)

Posted: **Wed May 12, 2021 9:22 am**

Basic question, I know, but how many ignition outputs are you using?

Posted: **Thu May 13, 2021 12:26 am**

SprinterTRD wrote:Basic question, I know, but how many ignition outputs are you using?

Two Ign Outputs (33 & 34)

***************************************************

Got information from Support, everything is OK - AUX 3 is only activated when system is "active" (= engine is running)

MoTeC Global Forum

MoTec M4, AUX 3 as PWM fan output

MoTec M4, AUX 3 as PWM fan output

Re: MoTec M4, AUX 3 as PWM fan output

Re: MoTec M4, AUX 3 as PWM fan output

Re: MoTec M4, AUX 3 as PWM fan output