M2r 36t trigger kit on fd3s running problem
Posted: Sat Nov 08, 2014 1:15 amI have goten a friend to do the wiring for me the wiring is 100% fine
Im havving problem seting up the new trigger wheel
It runs fine with stock mag sensors
These are the settings i have for the hall set up
Number of cylinders -2
Ref sensor type 1
Sync sensor type 1
Ref sync mode 83
Crank reff teeth 36
Tooth raito 50
Crank index position 60
Ignition type 140
Number of coils 4
It runs but only on front rotor thats what it sounds like im getting spark from all 3 coils and all 4 injectors im 100% sure its somthing to do with ecu setup when i put stock vf sensors in with there set up its fine
im confued to what i have done wrong in set up
I have emaild full function engineering but not yet had any reply so was hoping some 1 could help advise me on next step
Im unsure of how to go from here
Im havving problem seting up the new trigger wheel
It runs fine with stock mag sensors
These are the settings i have for the hall set up
Number of cylinders -2
Ref sensor type 1
Sync sensor type 1
Ref sync mode 83
Crank reff teeth 36
Tooth raito 50
Crank index position 60
Ignition type 140
Number of coils 4
It runs but only on front rotor thats what it sounds like im getting spark from all 3 coils and all 4 injectors im 100% sure its somthing to do with ecu setup when i put stock vf sensors in with there set up its fine
im confued to what i have done wrong in set up
I have emaild full function engineering but not yet had any reply so was hoping some 1 could help advise me on next step
Im unsure of how to go from here