Has anyone got the correct IJbc number for the dead time compensation curve for Sard injector that is carrying Nippon Denso part no on the side of housing that is as follows 195500-2240.Impedance for injector is 14 ohms.
It will be running on a SR20det engine running standard fuel press reg.I believe these regs are rising rate can someone confirm this?
regards ARE
correct IJbc for Sard injector (n.denso pt no -195500-22400)
2 posts
• Page 1 of 1
correct IJbc for Sard injector (n.denso pt no -195500-22400)
by ARE on Wed Oct 01, 2008 12:29 am
- ARE
- Posts: 4
- Joined: Thu Jul 24, 2008 9:24 am
Re: correct IJbc for Sard injector (n.denso pt no -195500-22400)
by JamieA on Fri Jan 30, 2009 9:15 am
At this point, we havent done a full calibration of that particular injector, so we dont have a full curve of it for you.
In that instance we suggest that you follow the dead time comp curve for an injector with simmilar characteristics.
Use this one with is another 14ohm denso injector with a simmilar part number.
In that instance we suggest that you follow the dead time comp curve for an injector with simmilar characteristics.
Use this one with is another 14ohm denso injector with a simmilar part number.
- Attachments
-
- inj comp.jpg (47.46 KiB) Viewed 6978 times
- JamieA
- Posts: 454
- Joined: Wed Apr 30, 2008 3:16 pm
- Location: Melbourne, Australia
2 posts
• Page 1 of 1
Return to M4 and M48 ECUs (including M2R and MLS variants)
Who is online
Users browsing this forum: No registered users and 17 guests